Recent content by Rajak

Hello, i have one VS with 3 ip addresses on vultr hosting. i have configured network settings like vultr says. then i make dash.conf file where i wrote #rpcuser=name #rpcpassword=password #rpcallowip=127.0.0.1 #listen=0 #server=1 #daemon=1 #logtimestamps=1 i have read this article...

Hello again. I also added IpV4 address to my server, then i configured my Network settings as it says vultr /etc/network/interfaces auto lo iface lo inet loopback auto ens3 iface ens3 inet static address mainIPaddress netmask XXXX gateway XXXXX dns-nameservers XXXXX post-up...

Thank you i will try to add new IP to my remote serv and then try this configuration. externalip=MN-ServerIP1 externalip=MN-ServerIP2 it must be like that yes?

Yes i am trying to run 2 masternodes on one IP.. so it is problem? what if i will add on server another IP address and then will try to activate another masternode with that IP... i am insteresting if would have 2 IPs and 2 masternodes is this configuration correct for it?

Hello in masternode.conf (for dash qt) i made settings like this MN900 MN-ServerIP:9999 PrivateKey1 TransactionNumber1 0 MN901 MN-ServerIP:9999 PrivateKey2 TransactionNumber2 0 and dash.conf in remote server (MN server) looks like #--- rpcuser=randomname rpcpassword=randompassword...

Hello, thank you for material i used it and it worked brilliant. I have 2 questions: 1) How an i set up 2 MN for 1 wallet? in masternode.conf (for dash qt) i made settings like this MN900 MN-ServerIP:9999 PrivateKey1 TransactionNumber1 0 MN901 MN-ServerIP:9999 PrivateKey2 TransactionNumber2...