Recent content by Garnett

I suspect there is a driver / software based controller involved. It has to be adjustable so its probably a change to the ROM. I hope we have some folks in the community with the time and inclination. All that said, running this at full speed with less than half the chips causes it to...

I was able to get a purchase in, but I'm worried for the difficulty by the time these arrive. There will be a lot of new D3's dropping at about the same time. I'm building out a D3 farm as well, since those will run in my "industrial" server farm at higher temps, but I'm having to rent colo...

Got it. So basically, the DM22G has much higher capacity (in terms of hashing chips) but is not pushing them as hard as they can go. So if we can keep them cold enough, and we increase the wattage on the power supply, we can throw our warranty to the wind and overclock these bad boys.

To further this question, I did confirm with iBeLink support that the DM22G does indeed run at 810W consumption. I have not checked the draw on the DM11G units, but I'm pretty sure mine are pulling the full 800W load due to some breakers flipping :). So how are we doubling the hash rate using...

I'm getting some really crazy hash rates and every 20-30 minutes or so, them miners reset. They were running fine for a while, but I switched the to the solo nice hash pool and now my hashing is misreported and my rejects are >30%. Is there something I need to adjust in the config...

So I had this happen over and over and over. I don't think the workers are other users though, they appear to be random worker names. What I ended up learning was that the web interface will "refresh" the page which causes the old pool URL and worker name to be repopulated in the text boxes. The...

This resolved my issue. Thanks! Now here's hoping I get a quick response on the volume order request for the 22GHs miners. :)

Interesting-thanks for the response. I have blue/amber lights from the boards posting but no link lights on network or dhcp requests. I only ran it for about 20 minutes though so I'll kick it back on to see if it can sort itself out.

Hey iBeLink team - I received my miners yesterday and one of them has a dead network card. No link lights, no connection. The other one works fine. I've tried multiple switches and multiple cables including the known good cable and switch from the working unit, but the network port will not...