挖矿简易教程：
A Quick guide for mining:
进入Miner 界面后，在Pools 矿池设置下输入你的矿池相应设置并保存。矿机会优先选择优先级数值越小的矿池，如果该矿池不可用，则会依次从小到大选择其他矿池。
In the Miner page, input your Pool's information. The Miner pick up the priority from low to high.
输入完毕后，会看到相应提示
After finish your input, you will get the notice.
返回到默认界面，可见矿机已在刚才设置的矿池中，开始工作。
Ok, now we go back to the default page. The miner is working in the right pools.
还可以直接通过切换矿池将矿机算力快速切换到其他矿池。(从我短暂的使用体验来看，我更偏重于从矿池设置页来进行调整。)
you may also change the pools in here. (From my point of view, i'm willing to do that in the Miner page.)
一些更多的图片供参考：
More pics for you~
3小时的挖矿效果：
The result of about 3 hr mining:
Source：
https://www.nicehash.com/?p=miners&a=3&addr=1NAfYGMrothKrzGqut3VmFLwfAWzYypqdF
用户体验：
Use Experience：
4颗40nm工艺的芯片提供150MH/s的挖矿速度，算力稳定。风扇声音很轻 经测试在45db左右，形象的比喻，同台式机CPU风扇的噪音相似甚至更低。连接方便，只需要电源和网线即可，基于web的管理配置，简单几步即可开始挖矿，很方便。
The 4 40nm process chips provides 150MH/s mining speed, very stable. The sound of the fan is very light, tested at about 45dB, just the same as your CPU fan noise or even lower. The assembling is convenient, and only need the power supply and the network cable. The management of web configuration provide an easy settings: by a few steps, you may begin to mine.
不知是不是问题的问题：
Don't know whether it is a problem:
在刚拿到机器的时候，首先在P2pool上面跑了20分钟，虽然在矿机设置上显示算力在150MH/s附近，但是在p2pool 矿池界面上却显示为2-3MH/s，会在这篇测试报告发布后，将算力返回到p2pool上面继续测试。敬请期待结果。
In the beginning, mining on the P2pool for about 20 minutes. Although the hashrate shows 150MH/s in Baikal's web page. But the P2pool's hashrate is just 2-3MH/s. Will be returned to the p2pool to continue to test.
Plaese STAY TUNED.
---- by Dash China Team.
apologize for seperated posts. i can not post more than 20 images in one post. So I just sub chapter release, the better
2/2
Hey guys~~Today a stranger joined Official DASH QQ group of China claimed his team has successfully made X11 ASIC Miner for X11. If that’s true, we’re gonna have the third X11 ASIC producer besides Ibelink and Pinidea. Here’s the detail:
