Activation will occur after 80% of blocks have signaled readiness within an approximately ~1-week window.
Is there a way to monitor the support for v.0.13 under miners ? Maybe some chart exists these days ?
If there is no way to monitor this, then can we at least get some info from time to time about the percentage of miningpools that upgraded ? (There should be an DCG internal doc about that somewhere)
From Post 1 :
Am i correct in assuming that the mentioned 80% of blocks could mean a few months and that the mentioned "1 week window" is to occur after those few months ? Or does this whole DIP0003 activation phase only takes a week ? (Which is remarkably short for a miners upgrade)
Yes, you should start it via usual "masternode start-<smth>" command only for now and wait for DIP0003 to register it as a deterministic one. This post above https://www.dash.org/forum/threads/dash-core-v0-13-on-mainnet.43130/#post-205630 outlines the migration process pretty good.When I am trying to run "protx register_prepare" I got an error message "non-wallet or invalid address". I can confirm this address by using "validateaddress" that it's from my own wallet. Do I after to do this only after DIP003 is activated?
The testing of 0.13.0.0 release candidates was extraordinary, because the changes were sweeping.Current v0.13 update progress :
45% of the masternodes updated (https://www.dashninja.pl/masternodes.html)
4,2% of the miners now show support for v0.13 (http://126.96.36.199/~pub/Dash/Dash_Info.html (v13 adoption)
Edit : miners support % seems subject to change at the moment, should be more clear in a few days
Miners support has started to increase the last hour and large exchanges have began updating their wallets
(Kraken did that today for its Dash wallet, through a planned maintenance session).
I suspect miningpools and large exchanges were waiting to see if there were any last minute hotfixes before
starting their update procedure. V0.13 has been remarkably stable so far.
There are several layers to this update, each layer equating roughly to the full process of previous upgrades. There's going to be a lot of entropy added by MNOs being unsure how to properly upgrade, too. Especially once DIP3 hits... If this is pulled off in merely 12 days, it'll be freakin' amazing.Why take long time? No! Not take long time! Farang pee bah!
Can we activate v14 features (ChainLocks) without waiting these miners to update their software? As far as I understand, 51% mining attack won't be a problem
Approx 1 week to lock-in DIP3 (if it stays at or above 80%)
Approx 1 week to activate DIP3
Then activation of sporks 15 & 16