Recent content by MK-KM

if be honest- i didn't get your point best regards

Thanks all for reply Can you advise me one more thing. I have 5 D3 Antmine and 1 Ibelink 11g. So average hash rate 106000 MH/s. Can you tell which payment method (PPS, PPLNS, SOLO or any other) will be better for this hash rate also please advise me best pool. Also let me know please why for...

Hello Everyone. please advise me regarding ant pool for Dash while i am using Ibelink 11g Please check attachments is it normal to get so many discards as i do (1-t image) Also i found that average hash rate in this pool is 1 gh lower that 11. it s actually hash rate is 10. Can anyone tell me...

hello again everyone ok, actually ibelink 11 g already non profitable. that's not good, but still lets accept this as already "done". Hope Obelisk will offer some solutions... So maybe is there any way just to somehow increase of earnings by changing of payment system PPLNS or PPS to any...

Hello Guys please tell me, you have similar problems with 11g- after rebooting or power off of the device all data is reset to default. IS that possible to save data and do not update it every time after each rebooting? best regards

So in normal way for Ibelink should be a problem to work in 198.168.1.120 and also 192.168.0.120. so group 0 is not a problem for Ibelink?

Can you be more specify, what do you mean under " sd card image gone bad. Please try to re-image the card." what actions should i do? best regards

Here are more details about situation Also i need to admit that after changing IP DNS and etc he start to reboot every few minutes. we change ip address from default 192.168.1.120 to 192.168.0.120 and when we go after reboot to ip 192.168.0.120 we found mistakes as i sent you in attachment...

Hello Everyone i tun ibelink for 1 mounts and i didn't get any problems but now i move it to other place so this place require to change IP address. i follow instructions, but after changing IP i had this message ( please check attachment) all options (roll back, reboot and etc) doesn't help...