What problem can be with my masternode on testnet? its already running for more than 7 days but I still don't receive payments. The same status from the beginning:
dash-cli -testnet masternode status
{
"outpoint": "45ce4e508d3cefd656d160cff9df64d85c97ffce1f6cc5d0335ea0aff7c5a9f5-1"...
I am just worried that after 3 days I have still the same:
"registeredHeight": 889898,
"PoSeRevivedHeight": 899874,
and all other info also the same or maybe its ok 🫣 :ninja:
Thank You! Finally a made it and run a masternode. I found the old wallet.dat file in my local MacBook (with which I registered masternode for the first time) and copied it to the server and after made update registrar/service commands and it works. One question: I run a masternode three days...
Thank u for the info! I downloaded now dashcore v19.1 for Mac, before opening change dash.conf file for the testnet:
testnet=1
# RPC Settings
rpcuser=user
rpcpassword=pass
rpcallowip=127.0.0.1
#----
listen=1
server=1
daemon=1
# Index Settings
txindex=1
addressindex=1
timestampindex=1...
I am using gui ssh wallet inside my terminal, when I am adding bls private key to dash.conf I am getting into masternode mode (not the wallet mode), I can use this command:
dash-cli -testnet masternode status
{
"outpoint"...
Thank u, I tried this command and found all info about masternode. But when I use protx update_service command I got:
"error code: -8
error message:
the operator key does not belong to the registered public key"
But it's impossible, i put there right bls private key (cause I found all keys...
I change port number in dash.conf and put this lines to the end:
[test]
port=12345
rpcport=19998
bind=0.0.0.0
rpcbind=0.0.0.0
After I registered new masternode with the same IP and new port (78.141.214.168:12345), but after protx register_submit I got this error:
error code: -26
error...
Thank u very much😇
I didn't find duplicated addresses but I found same IP and realize that its my masternode is in pose_banned list:
"45ce4e508d3cefd656d160cff9df64d85c97ffce1f6cc5d0335ea0aff7c5a9f5-1": " POSE_BANNED 527 ygt2DRQBLNAiokSzCpWxSk3dWVDeYj4AST 0 0...
Maybe I'm doing it in the wrong order?
First I am create new address for getting 1000tdash from faucet.
After I create another new address (collateral) and send there 1000tdash
After I wait for 15 collateral confirmations and create bls keys
After I paste the bls private key into dash.conf file...
Hello guys!
I am trying to set up my masternode on testnet via Mac terminal. I create and set up vultr vps and made all server configuration via this instruction:
https://docs.dash.org/en/stable/docs/user/masternodes/server-config.html#server-config
after I installed Dashcore via manual...
Hello, dear community, I have a problem in sync process between Dashcore wallet and blockchain, its a process before u got private master node key, Its going good until 95% but after its totally stock... And slowly start to decrease. I am already wait a lot, 3/4 days and I think it's not...