Search results

Vultr CPU: 1 vCore RAM: 512 MB Storage: 125 GB SATA Bandwidth: 2.03 GB of 1000 GB (0%) OS: Ubuntu 14.04 x64

Hi, thought I was fine. But I couldn't find my masternode in dashninja. So I startet your routine again (dashd, dash-cli masternode list full | grep "my IP" -> enabled. Now I can find my MN in dashninja. Do you know, why it went down?

sorry, I was away on job. But I followed your instructions and received an "enabled" and can find it on dash ninja. I have two reds: last paids, but this sounds normal reg my MN is new, right? Status Active (100%) Port Check Status Open Port Check Next Try 48 minutes 5 seconds Daemon Version...

couldnt find any .dashd command or process

ok, I did the ps aux on my remote. A long list appeared, which I cannot understand. What should I check there?

how can I solve my port problems?

ok, now I tried dashninja again and it found my master node´s IP does it mean, it works now correctly, even if the terminal gives me after /dash-cli masternode list full | grep <my MN IP address.> is the answer:"couldn't connect to server Status in dashninja: Status Active (100%) Port Check...

did it. Again: Start in console of Dash qt: "Masternode successful" but double check in terminal: ./dash-cli masternode list full | grep <my MN IP address.> is the answer: error: couldn't connect to server any idea?

si. any idea what i missed or did wrong?

Hi splawik21, thanks for your reply. I tried the dashninja.pl (ninja.pl was interesting as well;-)), but the IP of my remote server was not found. Any idea what went wrong, even if I received the message"started masternode successfully"?

sorry, I am not allowed to send links yet ;-) it is in dash.org/forum/threads a thread about masternode-setup-guide-using-os-x-local-linux-remote

Hi, I am an absolute beginner with linux but I managed with Babygiraffe´s guide to setup a master node on my Mac. At least I hope I have my masternode active now. And here my two questions: 1. In step 9 Step 9: Start your masternode(s) Now launch the Dash Qt and reopen a console session. Enter...

Hi babygiraffe, first of all, thank you very much for your tutorial. I had no knowledge about linux, VPS Server and terminals, but I think you navigated through and I hope I have my masternode active now. And here my two questions: 1. In step 9 I received the message "started masternode...